Chevron, Held to a Single Angle
Angled boards run up the face of this door in a repeating chevron, meeting at a center line that runs floor to head. Finished in a deep matte black, the seams between the boards become the only drawing on the slab, and the pattern shifts as you cross the room.
Chevron is easy to draw and difficult to build. Every board has to be cut to the same angle, every point has to land on the center line, and any drift accumulates as you work up the door. Miss by a degree at the bottom and the top is visibly wrong.
The dark finish is not a coincidence. Chevron in a light stain gets busy fast. In black the geometry survives and the wood recedes, which is the version worth building.
Design Details
True Mitered Chevron
Boards meet point to point on a single center line, each cut to the same angle. The pattern is built, not routed in.
Center Line Held Top to Bottom
The vertical seam runs dead straight through the full height of the door. It is the one line that cannot drift.
Matte Black Finish
Dark and flat, so the pattern reads as shadow and edge rather than as a busy field of grain.
Directional by Design
Point the chevron up and the door reads taller. It is a real choice, and we cut it the way your opening wants it.
Angles Are Unforgiving
A chevron face is dozens of mitered joints under tension, each pulling slightly against its neighbor. Only a solid, properly dried panel holds them closed. Ours are built to order in Bucks County, Pennsylvania, and if a joint ever opens on you, our lifetime warranty covers it.
Where This One Works Best
- Modern kitchens
- Pantry doors
- Home offices
- Primary bath entries
- Media rooms
- Laundry rooms
- Basement entries
- Closet openings
- Utility rooms
Made in the USA. Cut, assembled and finished in Bucks County, Pennsylvania. Lifetime warranty. Free shipping.










